How to include a wired mains node?
Posted: Wednesday 31 July 2019 20:12
I have 2 TKB Home TZ56 Wall Switches" Zwave+
Both are wired as mains light switches, and so can't be moved.
However, one has been marked as dead.
Normally the way to (re)add a node is to bring it near the controller, and include it.
The dead switch is not near the controller, but does have other nodes nearby.
Any thoughts on how to re-include it?
Both are wired as mains light switches, and so can't be moved.
However, one has been marked as dead.
Normally the way to (re)add a node is to bring it near the controller, and include it.
The dead switch is not near the controller, but does have other nodes nearby.
Any thoughts on how to re-include it?