Fibaro FGRM222 slats position
Posted: Wednesday 15 May 2019 22:12
Ok, a new stake on an old thread... , controlling the slats (venetian blinds) postition from domoticz...
Since I'm on the beta with openzwave 1.6 , something changed, I can now control these positions from within open z-wave (by putting in values in the OZWCP) but maybe you guys know how I can get a slider for these values in domoticz ? (sepperate IDX or not, does not matter)
This is reported in the log:
OpenZWave: Value_Changed: Tried adding value, not succeeded!. Node: 72 (0x48), CommandClass: MANUFACTURER PROPRIETARY, Label: Venetian Blind slat position, Instance: 1, Index: 0
Since I'm on the beta with openzwave 1.6 , something changed, I can now control these positions from within open z-wave (by putting in values in the OZWCP) but maybe you guys know how I can get a slider for these values in domoticz ? (sepperate IDX or not, does not matter)
This is reported in the log:
OpenZWave: Value_Changed: Tried adding value, not succeeded!. Node: 72 (0x48), CommandClass: MANUFACTURER PROPRIETARY, Label: Venetian Blind slat position, Instance: 1, Index: 0