How to make transceiver visible when connected to sysfs on Openwrt

[JeroenOW]

Hello everyone,

I'm trying to use simpel Kaku switches but can't make domoticz learn code from remote.

What i have now is working domoticz on very cheap hardware i got 433,92 Mhz receiver and sender on gpio 1 and 2.
Domoticz sysfs recognises both gpio's but i can't find a way to make domoticz learn the remote commands.

I have Python installed and it is being seen by Domoticz.
Anyone have any ideas to make the learning command work to simply switch on and off a KaKu controlled light?

Thanks in advance.