Philio PSt02-B PIR sensor not working
Posted: Saturday 11 May 2019 17:37
I have added the Philio PST02-B to my Domoticz and it shows up like this
The sensor (Idx 464) did not show up as a PIR, but a light. After I added it as a switch and changed it to a motion sensor it changed the icon.
But it still does not work. Other functions are updated, like temperature and lux, but not the PIR: no response at all.
How do I need to configure this thing? Any experience there?
I tried in hardware setup under RaZberry (OpenZWave USB). There is shows up as Philio Technology Corp PST02-B PIR/Motion 3 in 1 Sensor+.
But the configuration menu is not helping.
Any idea's?
- philio02-b-1.png (57.63 KiB) Viewed 547 times
But it still does not work. Other functions are updated, like temperature and lux, but not the PIR: no response at all.
How do I need to configure this thing? Any experience there?
I tried in hardware setup under RaZberry (OpenZWave USB). There is shows up as Philio Technology Corp PST02-B PIR/Motion 3 in 1 Sensor+.
But the configuration menu is not helping.
Any idea's?