Update Somfy blind status after command
Posted: Friday 03 May 2019 20:39
Hi all
I have a setup with Somfy blinds (1002295A Tilt&Lift 25 RTS Central) that I control via RFLink.
I have also setup the original Somfy remote as a Sub/Slave Device so that when I use the remote the Domoticz status is updated.
This is all working fine.
However, when I use Domoticz to control the blinds I cannot find a way to get the Domoticz status updated after the command is send.
I know the blinds will not reply a status I just want to fake the status so that they align as long as the command succeed.
Has anybody found a way to make this work ?
Thanks.
I have a setup with Somfy blinds (1002295A Tilt&Lift 25 RTS Central) that I control via RFLink.
I have also setup the original Somfy remote as a Sub/Slave Device so that when I use the remote the Domoticz status is updated.
This is all working fine.
However, when I use Domoticz to control the blinds I cannot find a way to get the Domoticz status updated after the command is send.
I know the blinds will not reply a status I just want to fake the status so that they align as long as the command succeed.
Has anybody found a way to make this work ?
Thanks.