[Advice]Migrating Domoticz from a RPi B to a RPi 2
Posted: Sunday 14 April 2019 13:38
Hello,
My Domoticz is today running on a RPi A with a Razberry gen 1 board. I have a RPi USB hub with Tellstick connected.
I bought a new RPi 3+ for my 3D print so I'm going to move my Domoticz to the RPi 2 that used to run my print.
I have also bought a Razberry Gen 2 board that I'm going to use.
Should I setup my RPi2 as master and keep the old as a slave?
Can/should I copy the DB between them?
How do I do with scripts and Tellstick conf?
Zwave devices needs to be readded?
TIA
Daniel
Skickat från min Nokia 7 plus via Tapatalk
My Domoticz is today running on a RPi A with a Razberry gen 1 board. I have a RPi USB hub with Tellstick connected.
I bought a new RPi 3+ for my 3D print so I'm going to move my Domoticz to the RPi 2 that used to run my print.
I have also bought a Razberry Gen 2 board that I'm going to use.
Should I setup my RPi2 as master and keep the old as a slave?
Can/should I copy the DB between them?
How do I do with scripts and Tellstick conf?
Zwave devices needs to be readded?
TIA
Daniel
Skickat från min Nokia 7 plus via Tapatalk