Domoticz

Posted: **Monday 01 April 2019 17:36**

Hello,

I would like to control my electric fireplace (with remote control on 433MHZ) from Domoticz.
The fireplace is from Ruby Fires type Varese.
When I use the learning mode and Domoticz shows me the message to use my remote, Domoticz is not able to recognize the transmission.
I use Domoticz on a Raspberry Pi with RFLink as the frontend.
I hope someone could help me with this issue

Regards,
Raymond

Posted: **Monday 01 April 2019 18:46**

rajsteverink wrote: ↑Monday 01 April 2019 17:36 Hello,

I would like to control my electric fireplace (with remote control on 433MHZ) from Domoticz.
The fireplace is from Ruby Fires type Varese.
When I use the learning mode and Domoticz shows me the message to use my remote, Domoticz is not able to recognize the transmission.
I use Domoticz on a Raspberry Pi with RFLink as the frontend.
I hope someone could help me with this issue

Regards,
Raymond

Did you check if the device is supported? http://www.rflink.nl/blog2/devlist That it uses 433Mhz does not mean it is.

Posted: **Tuesday 02 April 2019 0:12**

Thanks Sweetpants for your quick reply.

I have checked the list you mentioned but I can confirm its not on the list.
I was wondering what the procedure is to get it on the list.
Do you have info about that?

Raymond

Posted: **Tuesday 02 April 2019 7:47**

Send request to RFLink Stuntteam to include your device.
As input for their effort they probably will ask you for a logging.

Domoticz

ruby fires varese

ruby fires varese

Re: ruby fires varese

Re: ruby fires varese

Re: ruby fires varese