Domoticz kill RPI 2 access
Posted: Saturday 23 February 2019 16:33
Hi All
I have a strange one, could also be me, but here is my issue.
Install raspbian, i tried jessie and stretch - both versions lite and full, on my PI.
Set ssh to access it, configure via raspi-config and update. All working up to this point.
Then i install domoticz, i have tried both ways, the easy culr way and the hard full local compile and both give me the same result.
Domoticz seem to install fine, but complains about permissions.
I change the permissions to full, but even that does not work.
If i then do a reboot, i am unable to access my PI via SSH no matter what i do.
I have done a few installed before, but this is the 1st time i have this issue.
The reason i am doing a new install is that i had a SD Card failure, so need to install on new card.
Any idea what i can look at?
I have a strange one, could also be me, but here is my issue.
Install raspbian, i tried jessie and stretch - both versions lite and full, on my PI.
Set ssh to access it, configure via raspi-config and update. All working up to this point.
Then i install domoticz, i have tried both ways, the easy culr way and the hard full local compile and both give me the same result.
Domoticz seem to install fine, but complains about permissions.
I change the permissions to full, but even that does not work.
If i then do a reboot, i am unable to access my PI via SSH no matter what i do.
I have done a few installed before, but this is the 1st time i have this issue.
The reason i am doing a new install is that i had a SD Card failure, so need to install on new card.
Any idea what i can look at?