NEO COOLCAM Motion sensor devices
Posted: Monday 18 February 2019 14:52
I bought a NEO COOLCAM motion sensor device and added it to a network with my Raspberry Pi 3B+ and Aeotec Z-Wave Gen5 USB stick. Now, the following 7 devices show up in Domoticz:
1. Alarm level [switch] seems to be default off
2. Alarm Type [switch] seems to be always off
3. Sensor [switch] switches on if motion detected
4. Burglar [switch] switches on along with Sensor if motion detected
5. Alarm Type Burglar 7 [general] Event, default value: 0x08
6. Light [lux]
7. Temperature [temp]
The sensor, light and temperature all work okay, but what are the other devices used for?
1. Alarm level [switch] seems to be default off
2. Alarm Type [switch] seems to be always off
3. Sensor [switch] switches on if motion detected
4. Burglar [switch] switches on along with Sensor if motion detected
5. Alarm Type Burglar 7 [general] Event, default value: 0x08
6. Light [lux]
7. Temperature [temp]
The sensor, light and temperature all work okay, but what are the other devices used for?