Unable to set mode on RFXtrx433?
Posted: Sunday 06 January 2019 18:28
Hi all,
I have a RFXtrx433 that I've been happily using for years.
I got some new devices and need to enable to Lighting4 protocol, but it fails and gives me this error -
I am running the latest 1025 firmware on Domoticz 4.9701.
I have tried rebooting etc.
Any idea what else I can try please?
Other protocols already enabled - FineOffset/Viking, Blind T1/T2/T3/T4, AD/LightwaveRF, Oregon Scientific, HomeEasy EU, AC, ARC, X10.
Thanks.
I have a RFXtrx433 that I've been happily using for years.
I got some new devices and need to enable to Lighting4 protocol, but it fails and gives me this error -
Code: Select all
2019-01-06 17:24:27.368 subtype = Interface Command
2019-01-06 17:24:27.368 Sequence nbr = 14
2019-01-06 17:24:27.368 set configuration of the interface
2019-01-06 17:24:27.518 subtype = Wrong command received from application (3)
2019-01-06 17:24:27.518 Sequence nbr = 14
2019-01-06 17:24:27.624 subtype = Interface Response
2019-01-06 17:24:27.624 Sequence nbr = 15
2019-01-06 17:24:27.624 response on cmnd = Save I have tried rebooting etc.
Any idea what else I can try please?
Other protocols already enabled - FineOffset/Viking, Blind T1/T2/T3/T4, AD/LightwaveRF, Oregon Scientific, HomeEasy EU, AC, ARC, X10.
Thanks.