Domoticz

Hi,

I managed to flash a Sonoff ifan02 with Tasmota and I can control it via the web interface.
I do not know how to configure Domoticz however, to connect the fan.
In domoticz I configured a selector switch, but that is not working.
Does anybody have experience in configuring ifan02 in domoticz?

Thanks.

Same problem here, anyone find a solution? I can switch the light on via a virtual switch and created a second virtual switch of type button selector to control fan speed. Not working as expected. I guess the button state (x%) doesn't match the expected input (fanspeed 1 etc). What to do?

Old topic but thought i'd post the answer as I just configured it myself.
Make sure MQTT is setup correctly and working (eg with other Tasmota flashed devices(

Fan speed is to be defined as a selector switch in Domoticz (use dummy hardware) , the Idx (Domoticz devices tab) goes into Idx2 in the Tasmota Domoticz Config
Light is to be defined as a switch in Domoticz (use dummy hardware), the Idx (Domoticz devices tab) goes into Idx1 in the Tasmota Domoticz Config

Voilà