Qubino pilot wire with temp probe & domoticz polling issue
Posted: Sunday 25 November 2018 15:06
Dear all,
I have lots of Qubino pilot wire controllers, and they work great. Except when I tried connecting a temperature probe on one of them.
I switched on polling on the device in Z-Wave device panel, which is necessary on these devices for having the temperature refresh. It worked for a few weeks, after which the qubino suddenly stopped to respond (no temp refresh, and no response to pilot wire commands).
The qubino required a shutdown to work again. And then, after a few weeks, same story.
If I disable polling, the qubino works flawlessly. But the temperature is not refreshing anymore.
Do you know if this is an issue with the Qubino, or if this comes from Domoticz with the polling option? I asked the question to Qubino team, waiting their response.
Thanks!
I have lots of Qubino pilot wire controllers, and they work great. Except when I tried connecting a temperature probe on one of them.
I switched on polling on the device in Z-Wave device panel, which is necessary on these devices for having the temperature refresh. It worked for a few weeks, after which the qubino suddenly stopped to respond (no temp refresh, and no response to pilot wire commands).
The qubino required a shutdown to work again. And then, after a few weeks, same story.
If I disable polling, the qubino works flawlessly. But the temperature is not refreshing anymore.
Do you know if this is an issue with the Qubino, or if this comes from Domoticz with the polling option? I asked the question to Qubino team, waiting their response.
Thanks!