Only 3 devices added after inclusion?
Posted: Thursday 27 September 2018 7:46
Hello,
After inclusion of my my Qubino Thermostat ZMNHID, only 3 devices are added; 2x kWh and coll/warm mode. No power options or temperature read-out.
The parameters of the device in the Z-wave hardware section seem ok
1) I'm used to having all devices right away, after inclusion. On forum I have read that some devices are added later. Is that true?
2) Does 'allow new devices (for 5 minutes' needs to be on? (tried it, with inclusion without success)
3) there are 2 XML configuration files for the ZMNHIDx : S1 and S2. How does this work? Do I need to change anything there?
After inclusion of my my Qubino Thermostat ZMNHID, only 3 devices are added; 2x kWh and coll/warm mode. No power options or temperature read-out.
The parameters of the device in the Z-wave hardware section seem ok
1) I'm used to having all devices right away, after inclusion. On forum I have read that some devices are added later. Is that true?
2) Does 'allow new devices (for 5 minutes' needs to be on? (tried it, with inclusion without success)
3) there are 2 XML configuration files for the ZMNHIDx : S1 and S2. How does this work? Do I need to change anything there?