Danfoss + Razberry + Domoticz
Posted: Tuesday 25 September 2018 11:12
Hi,
I have been using Domoticz with a rasberry and rfxtrx433 for a couple of years and recently bought a razberry z-wave, a plug and two danfoss living radiator thermostats. No problem with the plug (from telldus) but I cannot seem to include the danfoss thermostats.
Under harware, in the razberry settings I manage to include the nodes. On the first try it did not give any name but after a repair the names popped up, they do however seem to be sleeping, see attached screenshot (I tried to enable polling on one of the devices but with no effect). In Domoticz I cannot see the nodes under devices so I cannot create switches.
On the thermostats the network and alarm icon are still flashing so the thermostat does not feel included.
Can anyone give me some advice? What have I done wrong?
Thanks,
Anders
I have been using Domoticz with a rasberry and rfxtrx433 for a couple of years and recently bought a razberry z-wave, a plug and two danfoss living radiator thermostats. No problem with the plug (from telldus) but I cannot seem to include the danfoss thermostats.
Under harware, in the razberry settings I manage to include the nodes. On the first try it did not give any name but after a repair the names popped up, they do however seem to be sleeping, see attached screenshot (I tried to enable polling on one of the devices but with no effect). In Domoticz I cannot see the nodes under devices so I cannot create switches.
On the thermostats the network and alarm icon are still flashing so the thermostat does not feel included.
Can anyone give me some advice? What have I done wrong?
Thanks,
Anders