manual state change of a gpio output not seen in Domoticz
Posted: Wednesday 19 September 2018 23:20
Hi all,
Domoticz is great, I can almost do all that I need to but...
Here's my setup: I configured the GPIO's as outputs, set them up in Domoticz, turn's them on and off and the state of the GPIO's changes and I can also see the change with the light that changes state (works great)
But I also need to be able to change the state of a output directly from wiringpi or sysfs and that Domoticz updates the state of this change.
Is this possible?
Thanks, David
Domoticz is great, I can almost do all that I need to but...
Here's my setup: I configured the GPIO's as outputs, set them up in Domoticz, turn's them on and off and the state of the GPIO's changes and I can also see the change with the light that changes state (works great)
But I also need to be able to change the state of a output directly from wiringpi or sysfs and that Domoticz updates the state of this change.
Is this possible?
Thanks, David