RFLink not recognized on my Pi
Posted: Tuesday 07 August 2018 12:06
Post by Tonio16 ยป 06 Aug 2018, 07:30
Hello
Since 4-5 days I don't succeed to plug my RFLink to my Pi. This RFLink had worked perfectly these last 2 months since I bought it at Nodo.
I am using Domoticz 4.9700 on a Pi3+. I have the last version of Raspian and only few other softwares (openvpn) since I made a new installation 3 days ago. I am using a SSD instead of a memory card which is using its own alimentation.
The problem is as follow. When I start the Pi, the RFLink is seldom regognized as USB device. If it is seen, after few hours I lost it, means no devices updated in Domoticz and an erreur message about RFLink.
I tried to plug-in after boot, no improvment.
On my computer no problem to plug it and I made a new upload of the driver (48.4). I didn't tried yet how long is the connection stable.
My assumption is that the the alimentation of the Pi or the SSD are dead and the electrical consumption is too high when the SSD, Pi and RFlink are running together. Could it be that?
Do you have some other suggestions? Shoudl I tried to change the Arduino board?
Tx for your help and regards
Antoine
Hello
Since 4-5 days I don't succeed to plug my RFLink to my Pi. This RFLink had worked perfectly these last 2 months since I bought it at Nodo.
I am using Domoticz 4.9700 on a Pi3+. I have the last version of Raspian and only few other softwares (openvpn) since I made a new installation 3 days ago. I am using a SSD instead of a memory card which is using its own alimentation.
The problem is as follow. When I start the Pi, the RFLink is seldom regognized as USB device. If it is seen, after few hours I lost it, means no devices updated in Domoticz and an erreur message about RFLink.
I tried to plug-in after boot, no improvment.
On my computer no problem to plug it and I made a new upload of the driver (48.4). I didn't tried yet how long is the connection stable.
My assumption is that the the alimentation of the Pi or the SSD are dead and the electrical consumption is too high when the SSD, Pi and RFlink are running together. Could it be that?
Do you have some other suggestions? Shoudl I tried to change the Arduino board?
Tx for your help and regards
Antoine