Domoticz

Raspberry Pi 3B
V4.9796

Both my Aeotec ZW096 Smart Switch 6 and Aeotec ZW099 Smart Dimmer 6 stopped reporting the messured mains voltage.
Up until juli 15th there was no problem.
When I look in the Z-Wave control panel, I can see the tension reading.

I have noticed the same today - changed the Parameter #101 to '15' and still nothing (101. Report type sent in Reporting Group 1:). Do see in OpenZwave Control Panel - also notice that the "Configuration" and "Information" and "Current Values" buttons are also no longer available (but that seems only to happen on Chrome on Mac Mojave - Safari works fine)