Domoticz

Posted: **Thursday 12 April 2018 19:39**

Hi
Does anyone know if RaZberry 2 EU supporting new Raspberry Pi 3 B+?
I have some problems with including new nodes, always i have ID 0x0000. I tried CoolCam Door Sensor, Fibaro Motion Sensor.
I can easily exclude 0x0000 nodes, so it looks like z-wave works.

Does anyone could help me?
I started few times from scratch with no effect.

2018-04-12 19:34:18.382 OpenZWave: Node Include command initiated...
2018-04-12 19:34:29.982 OpenZWave: New Node added. HomeID: 1431655765, NodeID: 11 (0x0b)
2018-04-12 19:34:29.993 OpenZWave: Value_Added: Node: 11 (0x0b), CommandClass: BATTERY, Label: Battery Level, Instance: 1
2018-04-12 19:34:29.993 OpenZWave: Value_Added: Node: 11 (0x0b), CommandClass: ALARM, Label: Alarm Type, Instance: 1
2018-04-12 19:34:29.993 OpenZWave: Value_Added: Node: 11 (0x0b), CommandClass: ALARM, Label: Alarm Level, Instance: 1
2018-04-12 19:34:29.994 OpenZWave: Value_Added: Node: 11 (0x0b), CommandClass: SENSOR BINARY, Label: Sensor, Instance: 0

: Devices.JPG (58.72 KiB) Viewed 1128 times

The attachment Devices.JPG is no longer available

Tomek

Posted: **Friday 13 April 2018 2:08**

It says node 11... Also the screenshot looks fine...
Maybe I miss understand something... Where do you see ID 0000?

Domoticz

RaZberry 2 EU - Raspberry Pi 3 B+

RaZberry 2 EU - Raspberry Pi 3 B+

Re: RaZberry 2 EU - Raspberry Pi 3 B+