Neo CoolCam Power plugs faulty or.. only L+ no LBR+
Posted: Tuesday 10 April 2018 10:09
Hi guys, I'm extending my z-wave network with a nr of extra power plugs to kill standby hardware and measure their power consumption. For this I now have 18 NAS-WR01ZE Z powerplugs connected to my Aotec Z-Stick Gen5 controlled by a raspberrypi2 with domoticz on top. This has been working for at least half a year but since I connected the last to powerplugs the network has become unreliable. Powerplugs not turning on at the specified time (using the switch timers in Domoticz). In Domoticz it shows as ON in the switch log and a minute later it registers the devices as off again (of course without me pressing any off button).
One thing I noticed is that in the openzwave controller page the last two powerplugs have only L+ (listening & zwaveplus) instead of the regular LBR+ (listening, beaming, routing, zwaveplus).
Do I have two faulty plugs?
One thing I noticed is that in the openzwave controller page the last two powerplugs have only L+ (listening & zwaveplus) instead of the regular LBR+ (listening, beaming, routing, zwaveplus).
Do I have two faulty plugs?
