L&S Systems LEDS - How to determine protocol?
Posted: Sunday 18 March 2018 15:56
Hi,
I have these L&S 'Emotion' leds in my kitchen. They can be remote controlled with some radio signal. I opened up one of the remotes, but I cannot figure out what protocol or frequency it is. Their website is not very helpful either. Could you point me in the right direction?
- Should I investigate, reverse engineer?
- Is it a familiar system?
- Should I just replace the whole rf system by a different one that is easier to link to domotics? If so, is there a standard system that can dim and change light temperature on LED lights with two wires?
- Should I just forget about this and buy a different lighting system?
Here is the receiver:
Remote inside
I have these L&S 'Emotion' leds in my kitchen. They can be remote controlled with some radio signal. I opened up one of the remotes, but I cannot figure out what protocol or frequency it is. Their website is not very helpful either. Could you point me in the right direction?
- Should I investigate, reverse engineer?
- Is it a familiar system?
- Should I just replace the whole rf system by a different one that is easier to link to domotics? If so, is there a standard system that can dim and change light temperature on LED lights with two wires?
- Should I just forget about this and buy a different lighting system?
Here is the receiver:
- IMG_4709.JPG (397.26 KiB) Viewed 1203 times