Domoticz

Hello,

The gas meter in my house was replaced. The new meter is now attached to the Smart Meter, but the old meter values also persist:

1-3:0.2.8(50)
0-0:1.0.0(180123145746W)
0-0:96.1.1(4530303333303036383234303236303137)
1-0:1.8.1(001875.015*kWh)
1-0:1.8.2(002089.101*kWh)
1-0:2.8.1(000000.000*kWh)
1-0:2.8.2(000000.000*kWh)
0-0:96.14.0(0002)
1-0:1.7.0(00.350*kW)
1-0:2.7.0(00.000*kW)
0-0:96.7.21(00009)
0-0:96.7.9(00003)
1-0:99.97.0(1)(0-0:96.7.19)(170110064735W)(0000000375*s)
1-0:32.32.0(00006)
1-0:32.36.0(00001)
0-0:96.13.0()
1-0:32.7.0(239.6*V)
1-0:31.7.0(002*A)
1-0:21.7.0(00.349*kW)
1-0:22.7.0(00.000*kW)
0-1:24.1.0(003)
0-1:96.1.0(4730303339303031363436313637373136)
0-1:24.2.1(171128165505W)(00467.277*m3)
0-2:24.1.0(003)
0-2:96.1.0(4730303332353635353434303332343137)
0-2:24.2.1(180123145509W)(00309.497*m3)

The 467.277 m3 is the old one, and 309.497 m3 is the new one.

Domoticz is set to read the old value, which now is static. How can I get Domoticz to read data from the new meter? Any help would be much appreciated.

Robert

I already searched around. None of the links found holds any relevant info on this subject. I have two gas meters in my reading, but I want to have Domoticz switch to the second reading.