Domoticz

Hello Guy’s,

Sinds i couple of days i am playing with a raspberry pi 3 and the rflink USB module.

I having troubles with finding my smartwares SH-RBS-04A.
Do i need a command for This?
Or Where Can i find i DIY to try it.

I am new with the raspberry stuff, back in the days i did a lot with arduino So i have a Little program skills

Did allow New HW Devices in Domoticz Settings?

Yes is did that.
my smartwares switch is a receiver so that is maybe the reason that I cant find it in de device list?
So I think I need some command to give him a address or something??
I have no remote or something like that from the same brand, only the wireless switch.

This is al new for me and I cant find a DIY about de rflink or rflinkloader.

you need something that can send to your smartwares switch so that rflink can pickup the code it is sending.
an another way is by hand via the switches page in domoticz (manual) only then you need to now the protocol and housecode for your switch.

mosjonathan wrote: ↑Sunday 22 October 2017 13:22 you need something that can send to your smartwares switch so that rflink can pickup the code it is sending.
an another way is by hand via the switches page in domoticz (manual) only then you need to now the protocol and housecode for your switch.

I have no remote so sending something to the switch is not possible.
I think i need to do it bij hand but that is now my problem.
I don't know the code that i must send to mu smartwares type: SH-RBS-04A.
I was hoping some one here did know that.

Maybe i need to buy the expansive kaku system to make it easy for myself?

Finally got it work, Now i Can go work in the doorbell and smoke sensor.
De doorbell code Can i see When i push the button.
So Now we Can go work on with that to get a message or something.

Thread Can be closed