Domoticz

Hi every one,

I recently bought a arduino mega connected my rf tranciver.
Installed the software on the arduino, checked if the setup worked on my laptop (it does).
After installation I connected the arduino to my raspberry and tried to learn my devices in domoticz.

Nothing happened....
Checked my logs:
After connecting it showed the RF link version
And received pongs from my RF link
No errors so far...

2017-10-15 21:41:20.495 RFLink: 20;8D;PONG;
2017-10-15 21:42:10.870 RFLink: 20;8E;PONG;
2017-10-15 21:43:00.816 RFLink: 20;8F;PONG;
2017-10-15 21:43:50.777 RFLink: 20;90;PONG;


I have a raspberry pi 2
I run domoticz version 3.8590
RFlink version 47
433 mHz devices impuls, pro max

Can anyone tell me what I'm doing wrong

Are your devices actually supported?
Check with rflink loader is you are receiving any devices.

Just to be sure.. you allowed domoticz to add/see new sensors ? (Settings -> System -> Hardware/Devices) ?

Stuntteam wrote: ↑Sunday 15 October 2017 22:02 Are your devices actually supported?
Check with rflink loader is you are receiving any devices.

devices are supported, i recive signals if i connect the arduino to my laptop.

HFman wrote: ↑Sunday 15 October 2017 22:05 Just to be sure.. you allowed domoticz to add/see new sensors ? (Settings -> System -> Hardware/Devices) ?

all ready checkt,