cheap chinese 433Mhz wireless relays
Posted: Tuesday 10 October 2017 23:10
Hi!
I bought a PCB with 433Mhz receiver and 4 relays on it. Together I bought a remote control with 4 buttons.
I can control each of the relays using the RFX manager. Protocol Lighting4 Decimal values: 1, 2, 4, 8 make activate all relays indivdual.
But how can I use these settings from Domoticz? RFX reports Lighting4, Sub.PT2264 and than the digital value : lots of 0's ending with 1 or 11 or 111 or 1111. Just what I choose from RFX manager .
Once I tried to learn Domoticz these settings with the bought remote control just one button can be used for learning.
They are called A,B,C and D. Only A can be used for learning. (Also B,C and D are not seen in RFXmanager.
I presume I'm not the first facing this problem but could not find a solution from the forum yet how to configure these (virtual?) switchses manual .
Looking forward to yr ideas.
KR
-Bart
I bought a PCB with 433Mhz receiver and 4 relays on it. Together I bought a remote control with 4 buttons.
I can control each of the relays using the RFX manager. Protocol Lighting4 Decimal values: 1, 2, 4, 8 make activate all relays indivdual.
But how can I use these settings from Domoticz? RFX reports Lighting4, Sub.PT2264 and than the digital value : lots of 0's ending with 1 or 11 or 111 or 1111. Just what I choose from RFX manager .
Once I tried to learn Domoticz these settings with the bought remote control just one button can be used for learning.
They are called A,B,C and D. Only A can be used for learning. (Also B,C and D are not seen in RFXmanager.
I presume I'm not the first facing this problem but could not find a solution from the forum yet how to configure these (virtual?) switchses manual .
Looking forward to yr ideas.
KR
-Bart