Honeywell Zwave thermostat
Posted: Tuesday 30 May 2017 8:44
I have a Honewell ZWave thermostat that I am trying to setup... hardware is as follows:
Running domoticz V3.7546 beta under Windows 7
When it is added it produces several items under the device list:
Thermostat Fan Mode General Thermostat Fan Mode Auto Low
Thermostat Mode General Thermostat Mode
Heating 1 Thermostat SetPoint
Cooling 1 Thermostat SetPoint
Furnace Thermostat SetPoint
Dry Air Thermostat SetPoint
When added to the interface via devices, the setpoints seem to provide a resonable control interface when the little flame icon is selected. But, the Modes devices provide tiles, that do nothing when the little circular icon is selected. I want to be able to select, cool, heat, off, etc., but cannot seem to. Also, is there some sort of composite tile that will put all of these controls together?
Running domoticz V3.7546 beta under Windows 7
When it is added it produces several items under the device list:
Thermostat Fan Mode General Thermostat Fan Mode Auto Low
Thermostat Mode General Thermostat Mode
Heating 1 Thermostat SetPoint
Cooling 1 Thermostat SetPoint
Furnace Thermostat SetPoint
Dry Air Thermostat SetPoint
When added to the interface via devices, the setpoints seem to provide a resonable control interface when the little flame icon is selected. But, the Modes devices provide tiles, that do nothing when the little circular icon is selected. I want to be able to select, cool, heat, off, etc., but cannot seem to. Also, is there some sort of composite tile that will put all of these controls together?