Aeotec Home Energy Meter Generation 5

[Bernhard]

System: Domoticz 3.7379 on Raspberry Pi 3 with Aeotec Z-Stick gen 5 and Aeotec 3-clamp Home Energy Meter gen 5.

I have for some time trying to get the Aeotec HEM Gen 5 working with Domoticz without any success.
The HEM is configured with no selective reporting, no polling and with reports of wattage for each clamp each
60 second. (Group 1 reports = 1792).

Looking at the OZW_Log.txt produced by Open Zwave library used by Domoticz the HEM are sending reports
showing all the three endpoints (see the attached file) so obviously the configuration of the HEM in Domoticz is working
(via the Zx095.xml file). These reports seems however to be completely ignored by Domoticz and are not seen
in the device section.

I have written this into several other sub-fora in the Domoticz forum without getting any answer. Maybe have used
wrong foras so I give this a last try in this sub-forum.

Are there any people reading this how is participating in the actual development of the Domoticz code who
could please tell me if the above problems depends on that the 3-clamp HEM Gen 5 is not yet implemented in
the Domoticz code. If this is the case, are there any plans to have it integrated?