Domoticz Community Forum - Support & Discussion

Hi,

Today i finished my high voltage control for my terrarium. It contains an RPI 3 , an 8channel relay card and a ULN2803 to invert the outputs of the RPI because the relay relay card is active high.



On the picture the GPIO link cable is not installed. All GPIO ports are availible on the interface board. Later i can add I2C and 1W devices to the interface board.

Now i can start creeating my blocky scripts.

Kind regards

mmm have a terrarium to...
You could build this with a esp relais board....
A string of Dallas is useful...
You can control then temp and hum to...


Bearded dragon?

1 leopard gecko I had 3 but they went ill and only one survived


2 viper geckos

mmm what are the black things you use in the first picture

Derik wrote:mmm what are the black things you use in the first picture

It is the back side of 3 "legrand 077112" 220V outlet socket mounted in a tripple frame .

I have 3 of this frames. 8 outlets controlled with domoticz and 1 constant 220V.

ok... when i found them i will upload some of my pictures...
I did setup my heating and light wit Zwave devices....
And a few esp for the tempsensors..