Set up EnOcean USB 300 USB-Gateway at Raspi
Posted: Wednesday 22 March 2017 12:44
Hi,
after I have managed to set up my Domotics on Raspi with the following Gateways
- RFXtrx433 E USB 433.92 MHz Transceiver
- Z-Wave Aeon Labs USB-Stick GEN5
I am now stuck with setting up my
- EnOcean USB 300 USB-Gateway 868MHz / TCM310 Chipset
Questions:
1. Will I have to install any Software in my Raspi Linux? If yes, which and how?
2. Which is the correct way so set up the new Gateway? How can I identify the correct Serial port?
So far I tried to add an EnOcean USB (ESP3) on various Ports, but it seemst to reamin unrecognized by Domotics. In the hardware list I do not get a blue "setup" button for this entry. What's wrong?
Thanks for any help!
Kifo
after I have managed to set up my Domotics on Raspi with the following Gateways
- RFXtrx433 E USB 433.92 MHz Transceiver
- Z-Wave Aeon Labs USB-Stick GEN5
I am now stuck with setting up my
- EnOcean USB 300 USB-Gateway 868MHz / TCM310 Chipset
Questions:
1. Will I have to install any Software in my Raspi Linux? If yes, which and how?
2. Which is the correct way so set up the new Gateway? How can I identify the correct Serial port?
So far I tried to add an EnOcean USB (ESP3) on various Ports, but it seemst to reamin unrecognized by Domotics. In the hardware list I do not get a blue "setup" button for this entry. What's wrong?
Thanks for any help!
Kifo