Device Recognzed but not at all
Posted: Monday 20 March 2017 16:24
Got a wired device...
cannot understand what's going on...
Scenario:
after a useless hardware reset of my AeonTec Gen5 Stick, I had to reinclude all devices I have...
it had'nt easy and I'm getting a wired problem with a switch:
devices 019 and 020 are the same but device 019 is not seen correctly.
I was 10 minutes before... than I don't know exactely what I've done to have this 'disappear'...
The switch is usable... domoticz can handle it and it correctly goes ON and OFF, but for an unknown reason the device is not seen correctly.
The same in the OWZCP... where the debug log show
tried to reinclude it... doesn't work (it is not recognized as a new device)
Tried to hardware reset the switch (keep pressing until flash)... no success....
Cannot really understanf what's going on with it
any clue or suggestion on how to proceed?
thanks
ciao
M
cannot understand what's going on...
Scenario:
after a useless hardware reset of my AeonTec Gen5 Stick, I had to reinclude all devices I have...
it had'nt easy and I'm getting a wired problem with a switch:
- Cattura-1.jpg (16.71 KiB) Viewed 344 times
I was 10 minutes before... than I don't know exactely what I've done to have this 'disappear'...
The switch is usable... domoticz can handle it and it correctly goes ON and OFF, but for an unknown reason the device is not seen correctly.
The same in the OWZCP... where the debug log show
I've tried to exclude the device... but the procedure does not goes ok and the device looks unremovableNode019, ERROR: Dropping command, expected response not received after 1 attempt(s)
tried to reinclude it... doesn't work (it is not recognized as a new device)
Tried to hardware reset the switch (keep pressing until flash)... no success....
Cannot really understanf what's going on with it
any clue or suggestion on how to proceed?
thanks
ciao
M