Page 1 of 1
Monitor Rfxcom signal strength with RaspberryPi?
Posted: Wednesday 22 February 2017 8:50
by Teknor
Hi all - wondering how to monitor the signal receive strength on the RFXtrx tranciever. Is there a way I can monitor this on a Raspberry Pi? I have a couple of extra antennas, but need to see the signal strength to identify where to place them.
Any tips are very much appreciated. Thanks.
Re: Monitor Rfxcom signal strength with RaspberryPi?
Posted: Wednesday 22 February 2017 20:23
by SweetPants
I think RFXmanager can help you with that
Re: Monitor Rfxcom signal strength with RaspberryPi?
Posted: Wednesday 22 February 2017 23:19
by Teknor
I know, but as far as I know it's only for windows and not Linux?
Re: Monitor Rfxcom signal strength with RaspberryPi?
Posted: Thursday 23 February 2017 8:46
by SweetPants
Teknor wrote:I know, but as far as I know it's only for windows and not Linux?
It used to run under mono too, but I did not use it recently if it still works