Domoticz

I have one of these. Use rfxcom on a Pi with latest current firmware. Supports the devices I have nicely. This motion detector is fairly cheap so would be nice to get going.

On a device learn/rfcxom scan it shows up as "Lighting 5" with sub-type "unknown". I'm guessing there's no support in there currently?

Anything I can do to help get it supported?

Cheers.

Interestingly it looks like you do get events. After defining the switch as a motion sensor, there are events logged at the right time. However instead of being an "on" followed by an "off" after the configured timeout, both events are reported as "off"... Something's definitely working...

Sent from my Nexus 5 using Tapatalk