SolarEdge inverter reported as usage in graphs
Posted: Tuesday 31 January 2017 10:19
Hi all,
first post here on this forum, don't know where to put this queston so hoping the mods can help me with that. Thanks in advance for any help!
I have Domoticz (v3.5877) running on a Pine64 (Linux Debian Jessie) connected to the P1 port of my smart meter. It all works flawlessly. Next to that, I have also connected my inverter (SolarEdge SE2200) to input its data into Domoticz. This integration works fine, but when I check the numbers reported by the inverter (production, voltage, wattage) it is all reported as usage and not as production.
See attached picture (Omvormer is inverter in Dutch btw). Both on PC and mobile this is shown as usage.
Is there a way to change this so it is reporting the data from the inverter as production?
Best regards,
Joris.
first post here on this forum, don't know where to put this queston so hoping the mods can help me with that. Thanks in advance for any help!
I have Domoticz (v3.5877) running on a Pine64 (Linux Debian Jessie) connected to the P1 port of my smart meter. It all works flawlessly. Next to that, I have also connected my inverter (SolarEdge SE2200) to input its data into Domoticz. This integration works fine, but when I check the numbers reported by the inverter (production, voltage, wattage) it is all reported as usage and not as production.
See attached picture (Omvormer is inverter in Dutch btw). Both on PC and mobile this is shown as usage.
Is there a way to change this so it is reporting the data from the inverter as production?
Best regards,
Joris.