Domoticz

Im new for domoticz and i dont understant lua

At first i have done notification when system is armed/disarmed, those run just fine.

Problem is this second phase when i am trying to send message if alarm is on and front door is open. (and later i will do same for all doors and motion sensors)
Sensor is Aeotec ZW112, and switch type is set to door lock. (i have tested others also, no help)
Nothing happens after saving this as active. ???




Everything works exept these blocky events.

Try to do it like this should work

I cant see any diffrence tham visual alignment?

I know my problem is in IF, ands second half.
I have tried with motion sensor and door switch, using on/off, open/close, motion/no motion,
NOTHING

Do part is tested and working.

Something strange is happening...

I did a full new rasbian and domoticz installations and devices setup. Now i got some of those events work.
Strangely 2 doors work now fine, other 2 dont.

All four are similar sensors, with similar preferences, and similar blocks.