Watermeter how to add (n00b question)
Posted: Monday 02 January 2017 0:19
I have a TCRT5000 hooked up to pin 3 (GPIO2) of my Raspberry P1 B rev.2 (planning for Pi 3 very soon, but assuming it will work the same)
With the GPIO readall command i can see the status of the sensor and it is detecting pulses from my watermeter.
I made a contact in switches to check if domoticz can read it and i can see the switch open en close.
But now i am stuck at the next step. How do i get the watermeter to count in my utility view. Bare in mind i am a n00b, so i need baby steps to get there. I've searched the forum but i am not able to filter out the information i need due to the huge amount of information that is presented here. If my question is allready answered in another topic, my apologies. (please point me to the right topic if that's the case)
With best regards and thank you in advance,
Martin
With the GPIO readall command i can see the status of the sensor and it is detecting pulses from my watermeter.
I made a contact in switches to check if domoticz can read it and i can see the switch open en close.
But now i am stuck at the next step. How do i get the watermeter to count in my utility view. Bare in mind i am a n00b, so i need baby steps to get there. I've searched the forum but i am not able to filter out the information i need due to the huge amount of information that is presented here. If my question is allready answered in another topic, my apologies. (please point me to the right topic if that's the case)
With best regards and thank you in advance,
Martin
