Aeotec KeyFob switch commands don't work

[wile]

Hi,
I've successfully included the 4 button key fob and changed to scene mode (took me some time to get so far).

The key fob switch is displayed as dimmer switch in Domoticz. By pressing the buttons on the key fob, I can see log entries like
2016-12-20 21:47:33.133 (Razberry) Light/Switch (Unknown)
2016-12-20 21:47:33.138 (Razberry) Light/Switch (Unknown)
2016-12-20 21:47:35.845 (Razberry) Light/Switch (Unknown)
2016-12-20 21:47:35.848 (Razberry) Light/Switch (Unknown)
2016-12-20 21:48:33.344 (Razberry) Light/Switch (Unknown)

However, the switch button in the GUI don't change. Actually, the buttons should send values:
Button 1 short press = 1
Button 1 long press = 2
Button 2 short press = 3
Button 2 long press = 4
Button 3 short press = 5
Button 3 long press = 6
Button 4 short press = 7
Button 4 long press = 8

But the switch keeps off. Any ideas to get this working?

Thanks
wile

[wile]

Sloved this now on my own.

Fyi, while there is only one selector switch in the device overview after inclusion, after some time switches representing the buttons are added in addition. Note, that these are always on, however, while pressing the button a On-Event is triggered.

Best
wile