Page 1 of 1
RPi, RFXtrx433e, Z-wave problems...
Posted: Tuesday 06 December 2016 13:26
by StefanB
Hi, I have a Raspberry Pi 2 with RFXtrx433e USB-controller and it's working fine. No I want to add Z-wave devices...
I add my Aeostick Z wave Gen 5 USB and the I try to open settings... Domoticz goes offline and stops updating on the RPi. The only way to get it working again is to reboot RPi. I'm stuck and don´t know where to look for the problem.. Any advice would be appreciated...
Re: RPi, RFXtrx433e, Z-wave problems...
Posted: Tuesday 06 December 2016 13:29
by LouiS22
StefanB wrote:Hi, I have a Raspberry Pi 2 with RFXtrx433e USB-controller and it's working fine. No I want to add Z-wave devices...
I add my Aeostick Z wave Gen 5 USB and the I try to open settings... Domoticz goes offline and stops updating on the RPi. The only way to get it working again is to reboot RPi. I'm stuck and don´t know where to look for the problem.. Any advice would be appreciated...
Hi,
https://www.domoticz.com/wiki/PersistentUSBDevices
Re: RPi, RFXtrx433e, Z-wave problems...
Posted: Tuesday 06 December 2016 14:53
by sach
What version of Domoticz are you running?
I remember there being an issue recently when Domoticz would go offline every time I set or requested requested the current stored values from a zwave device.
Re: RPi, RFXtrx433e, Z-wave problems...
Posted: Tuesday 06 December 2016 19:15
by StefanB
LouiS22 wrote:StefanB wrote:Hi, I have a Raspberry Pi 2 with RFXtrx433e USB-controller and it's working fine. No I want to add Z-wave devices...
I add my Aeostick Z wave Gen 5 USB and the I try to open settings... Domoticz goes offline and stops updating on the RPi. The only way to get it working again is to reboot RPi. I'm stuck and don´t know where to look for the problem.. Any advice would be appreciated...
Hi,
https://www.domoticz.com/wiki/PersistentUSBDevices
Thank you.... It did the trick...
Skickat från min iPhone med Tapatalk
Re: RPi, RFXtrx433e, Z-wave problems...
Posted: Wednesday 07 December 2016 10:05
by LouiS22
StefanB wrote:LouiS22 wrote:StefanB wrote:Hi, I have a Raspberry Pi 2 with RFXtrx433e USB-controller and it's working fine. No I want to add Z-wave devices...
I add my Aeostick Z wave Gen 5 USB and the I try to open settings... Domoticz goes offline and stops updating on the RPi. The only way to get it working again is to reboot RPi. I'm stuck and don´t know where to look for the problem.. Any advice would be appreciated...
Hi,
https://www.domoticz.com/wiki/PersistentUSBDevices
Thank you.... It did the trick...
Skickat från min iPhone med Tapatalk
Cool
