Change configuration of Fibaro Wall Plug device

[pipen]

I hope this is the right forum, very new here!

I'm trying to change the configuration of my Fibaro Wall Plug to turn of the LED (even when the device is ON). So in Domoticz (version 3.5877 running on my RBPi 2 with UZB1) I change the value of the device "61. LED ring illumination colour when controlled device is on:" to "Illumination turned off completely" and press "Apply configuration for this device". I know get a message saying "Configuration send to node. If the node is asleep, this could take a while!". Finally I press "Ok".

For some reason the Fibaro Wall Plug never turn of the LED.Am I doing something wrong?

Thanks in advance.

[Mauk59]

Hello Pipen,

I have my Domoticz installed with latest stable version on a NAS. My Fibaro Plug is recognize but as a Unknow device, I don't have the configuration's option below. Have you done something to have it? and by the have you managed to turn off the light?

Thank you