Qubino thermostat ZMNHID1
Posted: Friday 25 November 2016 11:23
I have installed a Qubino ON/OFF thermostat ZMNHID1 and it works fine.
My question is about how to change mode off/auto
When I included it I get several devices (temp, energy...) but I didn't get any switch, just a device General subtype Thermostat Mode. This device tell if thermostat is OFF or AUTO. I use a virtual switch and a LUA script to connect disconnect the thermostat (to change OFF to AUTO and viceversa). I know that I can change from AUTO/OFF editing this device in the web or in OZWAVE Control Panel.
So, I wonder how can I convert this device to a switch device, so I don't need a virtual switch. Is it posible?
PD: And if I push I1 in device it sends status to Domoticz but <i need another script to change virtual switch status.
My question is about how to change mode off/auto
When I included it I get several devices (temp, energy...) but I didn't get any switch, just a device General subtype Thermostat Mode. This device tell if thermostat is OFF or AUTO. I use a virtual switch and a LUA script to connect disconnect the thermostat (to change OFF to AUTO and viceversa). I know that I can change from AUTO/OFF editing this device in the web or in OZWAVE Control Panel.
So, I wonder how can I convert this device to a switch device, so I don't need a virtual switch. Is it posible?
PD: And if I push I1 in device it sends status to Domoticz but <i need another script to change virtual switch status.