Set General Alarm of Fibaro modules
Posted: Friday 28 October 2016 16:49
Hi,
I'm building up my alarm system with Fibaro sensors and fibaro switches.
When the alarm is triggered, I now start a blockly which results in flashing lights with a frequency of 1 sec. Very lame. In practice it's even 3-4 seconds. Doesnt scare anyone.
At the Hardware page, I see parameter 30 "Response to General Alarm".
How can I activate this?
I assume at least that when "General Alarm" is activated, the devices will flash in a way more alarming mode then the frequency I now have.
Thanks for your feedback guy's!
regards,
Christian
I'm building up my alarm system with Fibaro sensors and fibaro switches.
When the alarm is triggered, I now start a blockly which results in flashing lights with a frequency of 1 sec. Very lame. In practice it's even 3-4 seconds. Doesnt scare anyone.
At the Hardware page, I see parameter 30 "Response to General Alarm".
How can I activate this?
I assume at least that when "General Alarm" is activated, the devices will flash in a way more alarming mode then the frequency I now have.
Thanks for your feedback guy's!
regards,
Christian