Linking Marmitek SC9000 alarm panel
Posted: Sunday 25 September 2016 13:43
I'm having some troubles connecting my SC9000 with the RFXtrx433E.
I would like to set up two-way communication:
1) Domoticz --> SC9000 for putting the alarm panel in arm / disarm state when my Domoticz alarm is turned on (by app or remote)
2) SC9000 --> Domoticz for being able to arm and disarm my Domoticz alarm using the panel/keypad
In my case Domoticz is connected to all my sensors (433 MHz+Z-wave), my SC9000 panel has no devices and is only used as a user interface.
For handling situation 1) I made the Rfxcom send signals similar to a KR21 keyfob, which works fine.
The problem is that i cannot receive any signals from the SC9000 when it is being armed or disarmed.
According to section 10.5 of the manual (See http://www.haibrain.com/documents/downl ... 000_EN.pdf, warning: directing to download) the SC9000 is capable of switching external indicator lights when armed, however i cannot receive these.
I manually added X10 devices on address A1, A2 and B1 in domoticz, but these are never triggered by the alarm panel.
Does anyone have suggestions?
I would like to set up two-way communication:
1) Domoticz --> SC9000 for putting the alarm panel in arm / disarm state when my Domoticz alarm is turned on (by app or remote)
2) SC9000 --> Domoticz for being able to arm and disarm my Domoticz alarm using the panel/keypad
In my case Domoticz is connected to all my sensors (433 MHz+Z-wave), my SC9000 panel has no devices and is only used as a user interface.
For handling situation 1) I made the Rfxcom send signals similar to a KR21 keyfob, which works fine.
The problem is that i cannot receive any signals from the SC9000 when it is being armed or disarmed.
According to section 10.5 of the manual (See http://www.haibrain.com/documents/downl ... 000_EN.pdf, warning: directing to download) the SC9000 is capable of switching external indicator lights when armed, however i cannot receive these.
I manually added X10 devices on address A1, A2 and B1 in domoticz, but these are never triggered by the alarm panel.
Does anyone have suggestions?