Domoticz

I had a zwave device (greenwave powernode) which I had disconnected from any power for a few months.

Today I switched it on, but it wasn't synching anymore, therefore I re-added it on my z-wave network. This all works fine, but it got a completely new node ID.

The old devices are however still showing up in Domoticz...That's a bit surprising as I was assuming that removed nodes on my zwave network would automatically be removed from Domoticz?

Shouldn't those be deleted automatically? Or should I just delete them manually from the devices tab?

On the stick: (node 12 - 0x0c is gone)

In Domoticz, the devices are still there:

Domoticz will only add new devices from nodes. If you remove a node, you will have to keep track of the old devices yourself, and delete them.

cogliostrio wrote:Domoticz will only add new devices from nodes. If you remove a node, you will have to keep track of the old devices yourself, and delete them.

Ah..didn't know that.. many thanks for confirming this, I'll delete them manually!