Domoticz

HI,
I have connected my RFlink with Ser2net to a remote Domoticz server.
The RFlink with ser2net is connected to a Pi.
This all works, but it is instable.

Now troubleshooting, i am uncertain what serial settings should work for Ser2net.
Currently i have configured ser2net with the following config: I have a hard time finding in these fora what settings should work, so with this post I am seeking a confirmation of the above settings.
port 10003 is correct in domoticz
I am pretty sure about USB23 since I made this persistent in the Pi.
I remain uncertain about the "raw" and serial settings for RFlink.

it is in the protocol reference document.. 57600,N,8,1

@ home all is OK using this how adapt to rflink spec :
http://lesser-evil.com/2013/04/raspberr ... le-server/
To if it works get : http://rpiip:3001 and you will see all serial communication on the webpage