Domoticz

Hi,
Does anyone have zwave-plus based sensors working along with PowerMeter Reporting?

I am looking for:
Controller : aeon-zstick-gen5
Motion : Fibaro v3.2
Door : Fibaro v3.2
PowerMeter : TKB TZ88e with GEN5 -----> this is not reporting power along with above combination.

I am using domoticz v3.483, OZW v1.4.1

Is there any other GEN5 based power usage reporting sensors that work?

thanks.

Hi, I have a TZ88, it reports power usage if you enable poling.

Hi Stan,
just to confirm - Is your TZ88e a GEN5 and you are using in the zwavePlus network? i.e. the controller and other sensors are all Zwave-Plus?. So, does it report power usage in this combination.

Even if one of the sensors is Zwave-Only, then even the network will drop to zwave-only mode.

(more specifically)Does your network have aeon-zstick-Gen5 and Fibaro-Motion with v3.2?

thanks.

Z-Stick Gen-5
1 x TZ88e - Lib Ver 3, Protocol Ver 3.83, Application Ver 1.10
2 x AN-157 - Lib Ver 4, Protocol Ver 2.64, Application Ver 1.02
6 x FGMS-001 - Lib Ver 3, Protocol Ver 3.67, Application Ver 2.07
3 x FGK-101 - Lib Ver 3, Protocol Ver 3.67, Application Ver 2.05
1 x FGS-222 - Lib Ver 3, Protocol Ver 3.52, Application Ver 2.02

So a mixed system