No switches on Master visible
Posted: Wednesday 13 July 2016 8:13
Hi,
I try to work with two raspbarry boards. One is a 2b as master, the other is a 3b set as slave.
Both set with the same SD image and updated to the same Beta version.
Slave is using An USB zwave stick and an Piface board.
In the slave I created a user and set the devices.
In the log the connection is established. So far, so good.
The problem is that in the master only one switch is shown. The others are not.
Whatever I try, it only shows one.
Anyone an idea what goes wrong?
I try to work with two raspbarry boards. One is a 2b as master, the other is a 3b set as slave.
Both set with the same SD image and updated to the same Beta version.
Slave is using An USB zwave stick and an Piface board.
In the slave I created a user and set the devices.
In the log the connection is established. So far, so good.
The problem is that in the master only one switch is shown. The others are not.
Whatever I try, it only shows one.
Anyone an idea what goes wrong?
