Domoticz

Hi at all,

I have the GWM-4 Thunderstorm Monitor. It send the Data at the Serial Port.
Every Strike givs an Data Output.
With my USB/Serial Cable I can receive the Data from the Device.
As Hardware I select the Open Therm Gateway.
The Domoticz Protocoll show me the corret Data line (see Picture).
From this Data Line I need the red marked Values.
The 1. is the Number of the Strike,
the 2. the Distance in Km,
the 3. the Signal Level.

It is possible to display this Data on the Dashoard?
P.S. It is not possible to change the Data Format...

Torsten

No one any Idea how to read and display this Serial Data?
I had read many posts in this Board but I don´t find an answer.