Domoticz

I have just installed an Aeon Garage Door Controller.

Anybody that knows how to turn the sound off?
it wakes up the whole neighbourhood.

I can't manage to do it.
In the configuration options it is an explanation how to do but from the code shown i can't figure out how to do it.
The default code doesn't say anything to me when I compare it with the values to set.

Regards,
Mats

change the vallues to 0 in the openzwave config.

I have installed it today and I can switch from domoticz..

but learning the sensor didn't work. the controller doesn't flash like the instructions say,

I have 3 devices. my wish is to see when the door is moving (if not controlled by the switch but the normal remote controls. And I like to check the state of the door..

did that works with you?

You can also use a wave/mp3 sound which is silence I think I would try that.
http://www.xamuel.com/blank-mp3s/