Page 1 of 1
Z-wave Hardware ID"S
Posted: Saturday 21 May 2016 18:58
by mischa
Is there a simple way to determine which ID in the devices list is corresponding with
the ID in the Razzbery (z-wave) Hardware List? It seems that there is no logic between them.
- Knipsel.PNG (119.22 KiB) Viewed 906 times
Re: Z-wave Hardware ID"S
Posted: Saturday 21 May 2016 19:59
by CurrentThread
The device ID starts with leading zeros followed by the node ID.
Re: Z-wave Hardware ID"S
Posted: Sunday 22 May 2016 10:57
by mischa
@CurrentThread Don't think that it is correct what you are saying.
- Knipsel2.PNG (32.23 KiB) Viewed 872 times
- Knipsel3.PNG (25.94 KiB) Viewed 872 times
The above ID's are one device but the don't match leading zero's with node ID
IDX 11, 12, 13 are from the right paddle (2nd input)
Re: Z-wave Hardware ID"S
Posted: Sunday 22 May 2016 14:10
by mischa
If I do a seach suggested in this topic
viewtopic.php?f=6&t=11894&p=85587&hilit ... ist#p85587
Then it returns no results,what do i do wrong? Getting frustrated over this..