Domoticz

To anybody interested a few weeks ago I got me some KlikAanKlikUit ACM-1000 relay switches. I wired it up to a bedlamp in the meantime to test and finally today I got the Chuango PIR-910 motion detector. It paired in domotics quickly by learning a new switch and selecting motion sensor.

Did a quick blocky event to switch the lamp on if motion is triggered and I am happy to say it works great. Its still early days but I will update again if I do run into trouble but so far so good

The rflink website specifically makes mention of the PIR900 however this has been replaced by the PIR 910 that is pet friendly also.

Thanks for reporting this!

I am playing with a bit more advanced blocky event rules other than just switch on lights.


One question as I have not played with motion sensors before on domoticz. Should a PIR remain on a ON state or should it go to OFF state by itself after a while of no movement and this is specifically on 433mhz devices also?

Ahh i think I just had a dumb moment for a while. I set the off delay value for the PIR device and now its auto off after the amount of seconds I set.