Domoticz

Hi,

Does anybody know if the Avidsen doorbell will work on RFXCOM?
It uses the 433mhz channel.

Regards

These are the codes and the device itself

This device is not in the supported list, see chapter 2 of the RFXtrx User Guide.
However, you can try with RFXmngr and enable only Lighting4 or with an RFXtrx433E try also with only ByronSX enabled.

Ok, got some output in RFXmgr

chimed 2 times:
0913001500000000D580
Packettype = Lighting4
subtype = PT2262
Sequence nbr = 21
Code = 000000
S1- S24 = 0000 0000 0000 0000 0000 0000
Pulse = 213 usec
Signal level = 8
------------------------------------------------
0913001600000000D880
Packettype = Lighting4
subtype = PT2262
Sequence nbr = 22
Code = 000000
S1- S24 = 0000 0000 0000 0000 0000 0000
Pulse = 216 usec
Signal level = 8

Now to create a lighting4 switch in Domoticz.

I suppose the message cannot be used because a RF packet with all zeroes is received.

My thoughts exactly. However, a PT2262 device was suddenly in my unused devices list, around 300 times...
(ok, havent been there awhile, but )

I'm moving on ..