Domoticz

Hi.

Yesterday my Razberry card went sort of dead.
The only way I could revive, was completely start from Fresh.
As soon as I coupled the Razberry Card to my new Domoticz installation, all Nodes ever added to the Razberry, where visible at once. One by One I could figure out what Node is what hardware.

But at the same time all nodes also added all devices.
So suddenly I had 80 devices.
Most of them I figured out.

Now for my real question.

Is there a way to figure out what device belongs to what node?
I don't see any relation, and as some nodes at multiple devices at once, this is kind of messed up now.

grtz,
Twan

The hex id of the node is in the id of the device

so I have to look at the 0xXX of the Node which correspondents with zzzzXXyy of the device?

For most of the devices that's correct.
For some their's no link and you have to guess by last update time and status.

OK, thanx a lot.

I did now see some resemblance.

grtz,
Twan